3D Digitization

3D digitization of a model
3D digitization of a model

For the digital measurement of any shaped body, there is a "GOM - ATOS III" type 3D digitizer available. The system works using fringe pattern. The measuring precision is approx. 0.05 mm depending on the measuring volume. 

The application spectrum covers:

  • Surface feedback after modifications in the creation phase of vehicle contours (e.g. parallel use for wind tunnel measurements on models and real vehicles)
  • Comparison between virtual and real contours
  • Generation of surface models for subsequent simulations or for reproducing parts using "rapid prototyping"
© 2019 FKFS Forschungsinstitut für Kraftfahrwesen und Fahrzeugmotoren Stuttgart | Impressum | Datenschutz | AGB      
FKFS Facebook Page FKFS Xing Profile FKFS Linkedin Profile FKFS Youtube Channel